x-ray plates
英 [eks reɪ pleɪts]
美 [eks reɪ pleɪts]
【医】X线【硬】片
双语例句
- As there were strange marks on the X-ray plates taken of the mummy, doctors have been trying to find out whether the woman died of a rare disease.
由于在给这个木乃伊拍摄的X光片子上有奇怪的斑点，所以，医生们一直试图搞清楚这位妇女是否死于一种罕见的疾病。 - They also found something which the X-ray plates did not show.
他们还发现了x线片子上没有显示的东西。 - The design and fabrication of high aspect-ratio hard X-ray zone plates by X-ray lithography are studied.
对利用X射线光刻制作大高宽比硬X射线波带片的设计和制作工艺进行了研究。 - The fractures reduced under the monitor of "C" arm X-ray machine and were fixed by anatomical plates.
在C型臂X线机监视下行股骨上段纵切口，将骨折复位，解剖钢板内固定。 - Fabrication of High Aspect-ratio Hard X-Ray Zone Plates with Supporting Structures
带支撑结构的大高宽比硬X射线波带片制作 - X-ray phase zone plates have higher efficiencies than amplitude zone plates.
位相型波带片相对振幅型波带片具有更高的衍射效率。 - The good parts of observation is articulations manus and genus for the bone age evaluation in teen-agers with X-ray plates and the methods of bone age estimation were the subjective and errors at random.
目前，对儿童青少年骨骼年龄评价以手腕部及膝部较好，方法也较多，但主观性强，随机误差大。 - The influence of random zone position error, width error, interdiffusion and roughness on the efficiency of X-ray zone plates ( ZP) was analyzed by summing up the wavelets of every pair of rings.
使用振幅矢量叠加法，通过叠加X射线波带片每一对环带对焦点的贡献，计算和分析了随机环带位置误差、宽度误差、扩散和粗糙度对波带片的效率的影响。 - Methods 26 cases of displaced acetabular fractures were performed X-ray sheet, CT and 3D-CT before operation in order to determine the classification of fractures and how to operate. All the cases were fixed by reconstruction plates through the best approach.
方法对26例移位髋臼骨折根据术前摄片，CT平扫和三维重建确定骨折类型和制定手术方案，选择最佳手术入路进行骨折复位，并用骨盆重建钢板固定。 - We integrally investigated the fabrication of holographic Soft X-ray CZP, and suggested the full process of the fabrication of soft X-ray CZP, and the measurement of relative efficiency between phase zone plates and an amplitude zone plate was also carried out.
本文对全息软X射线聚焦波带片的研制进行了系统的研究，提出了完整的工艺路线，并对位相型波带片与振幅型波带片的相对效率进行了测量。 - Fabrication of Soft X-Ray Condenser Zone Plates
软X射线聚焦波带片制备工艺的研究 - Methods: 12 cases of displaced acetabular both-column were performed X-ray sheet, CT and 3D-CT to determine the diagnosis. All the cases were fixed by reconstruction plates and screws through combined ilioinguinal and Kocher-Langenbeck approaches.
方法：对12例移位髋臼双柱骨折行影像学检查，明确诊断，经Kocher-Langenbeck（K-L）和髂腹股沟联合入路，进行骨折复位并用重建钢板螺钉固定。 - By using microscope, SEM X-ray analysis and DSC analysis, the reasons for causing the surface blemishes of low foamed PVC-U integral door plates are found out, and the solution is provided as well.
运用显微镜、SEM-X光分析及DSC分析并找出了低发泡PVC-U整体门板表面缺陷的产生原因，提出了解决的办法。 - Fabrication of Ni and Ge X-ray phase condenser zone plates.
软X射线Ni和Ge位相型聚焦波带片的研制。 - X-ray standard for assessment of intervertebral fusion: there were no X-ray or photic region in titanium meshes and between inferior and superior lamina of vertebrae, synostosis existed between end plates, no activities among segments were found.
评估椎间融合的X线标准：在平片上钛网与上下椎板之间没有X线透光线或透光区，上下终板间有骨性连接，在伸屈位片上节段间没有活动。 - Based on the basic principle of X-ray transmission tomograph, an obliquely incident X-ray radiography is developed to measure the maximum depths of corrosion pits in automobile metallic plates with reasonable cost.
基于X射线透射造影术的基本原理，提出了一种简易的X射线斜透射测量技术，用以测量金属（铝/钢）板材上腐蚀坑的最大深度。 - Characterization of Relative Diffraction Performance of Soft X-Ray Zone Plates by Experiment
软X射线聚焦波带片相对衍射特性的实验研究 - Methods: A I-year imaging follow-up observation of 34 cases with diagnosis of SARS confirmed staying and receiving treatment in our hospital, contents of follow-up observation consisted of frontal and lateral chest x-ray plates, frontal X-ray plates of pelvis and CT scanning.
方法：对在我院住院治疗的34例SARS患者进行的影像学检查随访观察1年，随访内容包括摄胸部X线正侧位、骨盆正位片及CT扫描检查。 - From the X-ray allograft of cortical plates were fused with host bone in the alcohol group and no fusion in the fresh group.
术后12周冷冻、酒精组X线片均见异体皮质骨与宿主骨融合一体，新鲜组则未见融合。 - The influence of random position error of zones, width error of zones, interdiffusion and roughness on the efficiency and resolution of X-ray zone plates ( ZP) is analyzed by adding the analytic expression of the diffraction field of every ring.
利用叠加所有圆环的解析近似衍射场的方法来计算和分析随机环带位置误差、宽度误差、扩散和粗糙度对X射线波带片的效率和分辨率的影响。 - Analysis of the influence of fabrication errors on the efficiency of X-ray zone plates by summing up the wavelets
振幅矢量叠加法分析X射线波带片加工误差对效率的影响 - Analysis of Influence of 4 Fabrication Errors on X-ray Zone Plates by Summing up Diffraction Fields
用衍射场叠加法分析四种误差下的X光波带片 - Experimental results show that the method is more sensitive and accurate than the incremental hole-drilling method and X-ray diffraction method, and suited for measuring interior residual stresses in engineering rolled plates.
研究结果表明，裂纹柔度法与逐层钻孔法及X射线衍射法相比，具有更好的敏感性和精确度，可用于测定板类构件内部残余应力。 - In this contribution we discuss the possibility to design a modified Transmission X-ray microscope using fractal zone plates ( Fzps) as diffractive optical elements.
我们讨论了利用分形波带片作为衍射光学元件的改版透射式X射线显微镜。 - X-ray condenser zone plates ( CZP) focalize and disperse X-ray, and x-ray micro zone plates ( MZP) serve as the imaging component for the sample, which are both the key components in soft X-ray microscope.
软X射线聚焦波带片对X射线色散和聚焦，软X射线成像波带片对样品成像，是软X射线显微镜中的关键元件。